Module name: s_isoupar

____________

Module declaration: GLOBAL GEOMETRY MODULE s_isoupar

___________________

Module description:

__________________

Create U isoparameter curves on a surface

2006-03-25 Gunnar Liden

Algorithm

1. Retrieve number of patches. Calls of GETSURH.

2. Create U parameter lines

Module parameters:

___________________

REF s_id > "@t16 Select surface";

INT n_u := 30 > "@ Number of U parameter lines");

No called modules

This document was created 2006-03-25 by module m_extdoc1

Module name: s_isovpar

____________

Module declaration: GLOBAL GEOMETRY MODULE s_isovpar

___________________

Module description:

__________________

Create V isoparameter curves on a surface

2006-03-25 Gunnar Liden

Algorithm

1. Retrieve number of patches. Calls of GETSURH.

2. Create U parameter lines

Module parameters:

___________________

REF s_id > "@t16 Select surface";

INT n_v := 30 > "Number of V parameter lines");

No called modules

This document was created 2006-03-25 by module m_extdoc1